A have a couple of projects in the planning phase that involve adding custom hw to the gumstix via the 60 pin Hirose connector.

In the past I've prototyped using a tweener, breakout gs, and flying blue wires to a prototyping board.  It works, but it's not pretty and the physical stability leaves much to be desired!

I'm going to bite the bullet and do a somewhat general purpose 60 pin prototyping PCB.

At a minimum it will combine the functionality of the tweener and the breakout gs and include a prototyping area (.1" grid of through holes).

Before I proceed though, I thought I'd check to see if anyone on the list knows of the existence of something like this.

If not, feature suggestions are welcome.  Perhaps I can find a way to make the boards available to others.

Steve