Hi everyone

I have been doing some research into the sleepmode that is apparently available for the PXA255 and therefore the basix-200 computer.

Some of the information says that it is as simple as echoing 'standby' or something else to /proc/sys/state or /sys/power/state.

but neither of those variables are available.. I haven't tried creating them - though I guess that is safe to try.

Is there a module I need to run to access the low-power standby modes of the basix? do I need specific kernel support enabled aswell?

the other very interesting tidbit I've found is that apparently I can set the RTC to "wakeup" the cpu using an alarm.. that would be very useful, but I haven't found any good details on how to drive the RTC alarms. any help there would be appreciated aswell.

Best regards
 
Matt Bowles
Embedded Systems Engineer
aWma Pty Ltd
Water Control Solutions
Design - Manufacture - Install
-------------------------------------------------------------------------
Phone 0427 680 641

Web www.awma.au.com   Email matthew@awma.au.com