Re: [Devil-linux-develop] 1.3.6 5/31/2008 I can't start eth0?

[Heiko Z. <he...@zu...>]

Hey,

Quoting John Boden <sag...@gm...>:

> Hi Heiko,
>
>> did you set up the interface via the setup program?
> yes
>
>> It would also be helpful if you post your ifcfg-eth0 file here.
> I did not hand edit it, but I will gladly retype it here to avoid ambiguity.
>
>> cat /etc/sysconfig/nic/ifcfg-eth0
>
> DEVICE=eth0
> ONBOOT=yes
> MODULE="eepro100"
> DHCP=yes
> IP=
> NETMASK=
> BROADCAST=""
>
> & lspci shows
> .. Intel Corporation 82557/8/9 Ethernet Pro 100 (rev 08)

Use Intel's e100 module, that one should work.

-- 

Regards
   Heiko Zuerker
   http://www.devil-linux.org


----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.