From: Arno L. <al...@it...> - 2008-06-29 22:38:50
|
Hi, 29.06.2008 17:25, James Bowes wrote: > Hi folks. > > I am stumped. Previously I was able to successfully test the both drive > and changer using btape. Then I started getting I/O errors... > > I was going to redo the bacula set up but so far I can even get to that > point. I can't even get a status from the tape device /dev/nst0. I made > sure all the bacula-daemons did not start on a reboot but nst0 is still > busy - all I get from mt -f /dev/nst0 is /dev/st0: Device or resource > busy. You can check with lsof which process has the device open. If that doesn't tell you anything, try this: find /proc/ -wholename '/proc/*/fd/*' -ls | grep st0 That should tell you which process (id) uses the device. Arno > Using Ubuntu 8.04, Bacula 2.2.8 and a DLT8000. > > Thanks for any pointers or suggestions. > > --james > > > ------------------------------------------------------------------------- > Check out the new SourceForge.net Marketplace. > It's the best place to buy or sell services for > just about anything Open Source. > http://sourceforge.net/services/buy/index.php > _______________________________________________ > Bacula-users mailing list > Bac...@li... > https://lists.sourceforge.net/lists/listinfo/bacula-users > -- Arno Lehmann IT-Service Lehmann www.its-lehmann.de |