Re: [Alsa-user] Output to analog and SPDIF simultaneously?
Brought to you by:
perex
From: <js...@od...> - 2004-07-10 00:09:50
|
I've set the SPSA mixer level to zero, enabled the IEC958 checkbox in AlsaMixer=2E I ran iecset, but wasn't clear what the parameters ought to b= e=2E Here is the output: Mode: consumer Data: audio Rate: 48000 Hz Copyright: protected Emphasis: none Category: PCM coder Original: original Clock: 1000 ppm Do you see any parameters that should be different? Thanks a lot=2E Original Message: ----------------- From: Clemens Ladisch clemens@ladisch=2Ede Date: Fri, 09 Jul 2004 16:34:29 +0200 (METDST) To: jscott@oddpost=2Ecom, alsa-user@lists=2Esourceforge=2Enet Subject: Re: [Alsa-user] Output to analog and SPDIF simultaneously? J=2E Scott wrote: > I'm trying to figure out a way to output audio on both the analog > and the SPDIF outputs simultaneously=2E I'm currently using the > onboard audio on a Biostar M7NCG 400 mobo with an nvidia chipset=2E Set the "SPSA" mixer control to 0, set correct parameters with the iecset utility, enable the "IEC958" control, and try playing to hw:0,0=2E HTH Clemens ------------------------------------------------------- This SF=2ENet email sponsored by Black Hat Briefings & Training=2E Attend Black Hat Briefings & Training, Las Vegas July 24-29 -=20 digital self defense, top technical experts, no vendor pitches,=20 unmatched networking opportunities=2E Visit www=2Eblackhat=2Ecom _______________________________________________ Alsa-user mailing list Alsa-user@lists=2Esourceforge=2Enet https://lists=2Esourceforge=2Enet/lists/listinfo/alsa-user -------------------------------------------------------------------- mail2web - Check your email from the web at http://mail2web=2Ecom/ =2E |