Hi Jürgen,
you wrote:
> I found the pinout of the hauppauge receiver as follows:
Thank you for the info. I was just on the way, to take the
piece apart. But you Ascii-Art is a little bit broken on the
way:
>
> ------------- ___ __________
> | | ___> 2.5mm Plug | 1 2 3
> | SFH 506 from below
> -------------
> ------------------
> ^ ^ ^
> Gnd Sig +5V 1: Gnd 2: +5V 3:
> Signal out
Would it be possible, to send it again. I'll perhaps be able,
to draw the information from the above, but I'm not 100% sure.
Martin
|