"Craig Barnes" <craig.barnes@...> writes:
> I've just upgraded my MB from an Intel LX to an Intel BX.
> Also I added a second processor. 2x 400Mhz
> Since then I've recompiled the kernel and added SMP support, made sure that
> modules are loadable and that the serial ports are loadable drivers, but
> no longer works.
> I've tested my hardware on another machine and all is well. I get no
> error messages at all.
> I've ran mode2 and get no response whatsoever.
> Any ideas?
I have a very similar problem. I'm using a realmagic receiver and it
work with my laptop and with one of my desktop machines. This desktop
has an additional IO card for the receiver.
When I connect the receiver to two other desktop (one is SMP) the
reciever dosen't work (onboard serials). Dosen't work means the
receiver gets power when a lirc application is running an the led
indicating receiving blinks but the lircd gets no input. The same
behavior can be procuced with a very simple test programm I wrote.
When I measure the voltage on the receive pin I can see negative
values for the laptop and the desktop with IO crad when the receiver
gets no IR signal. The two desktop where the receiver dosen't work
have a small but positive voltage in this case. I assume this is the
Due to the fact that the two desktops (especial the one wehre the tv
card lives in) has no free solt I can't put the IO card in the system
to solve the problem. I tought about running lird on the other system
where it works and get the signal output via network pipe to the
system with the tv card... only idea in the moment.