Stefan L=FCthje sagte:
> Nils Trebing sagte:
>> Andrea Rossato wrote:
>>> Hi there!
>>> First of all I would like to thank the developers for their great job=
>>> the wireless card of my Toshiba Portege R100 is eventually working!
>>> My config:
>>> the card should be an Intell PRO/Wireless Lan 2100 (lspci give unknow=
>>> device, though), Im'm using ndiswrapper 0.4 and intell2100b.zip drive=
>>> (from the ndiswrapper home page).
>>> With no encription the card is working just fine. I tried to set a
>>> key (following the various tips found in this mailing list). I cna se=
>>> it and I can get it working, but for not more than a couple of minute=
>>> either in restricted and open modes. Then the connection stops workin=
>>> Anyone with a similar problem? Any idea?
>> I have the same card on an IBM ThinkPad R40 2722-5MG. Without WEP the
>> connection is very stable, but with a 104 bit key set, the connection
>> sometimes stops working after one hour, sometimes after 5 minutes,
>> sometimes after two hours,...
> I have the same problem with the current CVS versionand 128-Bit WEB, tw=
> weeks ago everythink was fine. The connection was stable without proble=
> Now the problem occours, when I receive a lot of data. But what I see i=
> that my access point L-DINK AP 900+ is rebooting???
> Is the box out of order, buggy firmware or a problem with the ndiswrapp=
After an Firmwareupdate from 2.56 to 2.61, the AP is not crashing anymore=
but the WLAN card Intel 2100 3B hangs again during a high traffic rate.