Thanks yea you are right.
I tried jbod mode in the same controller and it works fine.
On Sat, Jul 28, 2012 at 12:44 AM, Alex Samorukov <ml@...> wrote:
> Megaraid tunnelling layer is very limited and buggy. Not all commands are
> working as expected. In this case CDB is filtered by controller, probably
> only way to send this request is to connect drive directly. Smartctl have
> nothing to do with this, as well as platform drivers.
> On 07/28/2012 01:47 AM, Suresh Dhanarajan wrote:
>> I am using smartctl version 5.43 with lsi megaraid controller.
>> I configured a raid 0 volume and tried to reset the sas portocol
>> specific page with the below mentioned option,
>> smartctl -l sasphy,reset -d megaraid,71 /dev/sdb
>> It fails with an error message,
>> scsiPrintsasphy Log select reset failed.
>> When i checked the uart message of the controller i seeing a iilegal
>> req cdb being sent to the controller.
>> Any body seen this issue and is there a way to use the reset page.