Still looking for help if anyone is out there.
On 04/21/2012 11:14 AM, Cory Coager wrote:
> I'm using a URC MX-980 remote connected to commandIR via cable. I'm
> using version lirc 0.9.0.
> The remote is intermittently missing IR commands on key presses. If I
> watch with irw I can see sometimes when I press a key nothing displays
> on irw. If I hold the button, still nothing. However, the next key
> press may work fine. I'd say there is about a 20% error rate which is
> enough to be annoying.
> How do I tweak my setup to be more reliable?
> Here is the top part of the remote config:
> begin remote
> name mx980
> bits 16
> flags SPACE_ENC|CONST_LENGTH
> eps 30
> aeps 100
> header 8977 4433
> one 606 1636
> zero 606 501
> ptrail 606
> repeat 8976 2190
> pre_data_bits 16
> pre_data 0xA10C
> gap 108320
> toggle_bit_mask 0x0