On Thu, Apr 30, 2009 at 11:17 AM, Bill Morrison <hipgnosis@...> wrote:
> I have a Connex board that I'm trying to get to work with a NetCF board.
> While the compact flash and network interface are accessible through
> the GUM interface it does not appear visible once the unit actually
> boots up. Trying to access the devices from the terminal inevitably
> fail. Also, the NIC itself doesn't appear to be powering up on boot -
> the link stays dead unless I access it through GUM.
> I have updated the unit with the pre-built binaries at
> (the updated uImage and have tried several of the builds) with no
> Any suggestions on how to get the NetCF card to work would be greatly
I seem to recall that the NetCF and NetMicroSD use slightly different
Some versions of buildroot autoswitch, and others require that the
correct one be loaded.
Check the /etc/modules and try swapping drivers.
or vice versa.
Shuswap, BC, Canada