Thanks Dave, the mod worked, the ttyS2 (STUART) device works
perfectly after the changes. The bluetooth network came backup too
though I am not sure if they are directly related.
On 10-Dec-07, at 2:17 PM, Lawrence Harris wrote:
> Thanks Dave, I forgot to look on your site. The references I found
> the original board became the console-HW and I remember seeing the
> some time back but for the life of me I couldn't figure out what to
> into the wiki search or Google to find it. I'll try it tonight.
> Many thanks, Lawrence
> Dave Hylands wrote:
>> Hi Lawrence,
>> On Dec 10, 2007 12:50 PM, Lawrence Harris <gumstix@...>
>>> I have an original Waysmall console board and a basic40-BT
>>> and would like to get the bluetooth and second serial port
>>> working. I
>>> have seen references to the hardware patches 'cut and jumper' to
>>> do this
>>> but for the life of me I can't find the instructions on the
>>> wiki. If
>>> anyone has a reference to which lines to cut and what jumpers to
>>> I would be most appreciative. I am trying to do some setup on an
>>> waysmall while I wait for the new verdex boards to come back into
>> I think that the mod was to convert an console-HW into a console-ST.
>> I have my own photo that I created over here:
>> You'll want to zoom in on the web browser to get the full-res
>> You need to cut the traces on the top side where the dotted red lines
>> are, and add two wires where the black lines go.
>> Because the cut lines are between vias, its fairly easy to go back by
>> removing the wires you added and putting jumpers on the top side over
>> the cut traces.
> SF.Net email is sponsored by:
> Check out the new SourceForge.net Marketplace.
> It's the best place to buy or sell services for
> just about anything Open Source.
> gumstix-users mailing list