On Nov 21, 2007 5:14 PM, Christian Schumann <schumann@...>
> On Wed, Nov 21, 2007 at 04:50:30PM +0000, Chris Birkinshaw wrote:
> > When I open alsamixer I see only controls relating to the sync and
> > rate settings for my HDSP 9652 (of which there are about 15). This
> > includes status displays for sample rate and sync source which are
> > correctly - when I connect SPDIF this is reflected in the display.
> > However, there are no level controls for inputs and outputs at all.
> If I
> > do an aplay -l, or arecord -l I get the device listed, but it has no
> > at all.
> > Has anyone else seen this before? The card works fine in windows.
> There's a special mixer application called hdspmixer for this. It's part
> of the alsa-tools package.
So I can't use alsactl and amixer to restore levels from the command line?
amixer does not show any level controls either.
Do you know why there are no PCMs listed?
I wondered if it was a firmware problem, though all the messages in the
groups about that are quite old and I have a recent alsa driver. It's not
obvious what the current supported firmware version is. I can find 104 and
106 on the RME website, but nothing older.