I built the latest buildroot, added python, uisp and some minor
additions over the defaults.
I copied it to the gumstix with hyperterminal. I ran a crc32 check
after uploading and it matched.
Immediately on booting I noticed errors from modprobe.conf, saying it
was ignoring invalid lines (two of them) starting with "-e". The lines
in question are here:
options hostap_cs ignore_cis_vcc=1
options orinoco_cs ignore_cis_vcc=1
install pcmcia /sbin/modprobe --ignore-install pcmcia && modprobe pxa2xx-cs
-e alias mwlan0 cfio
install cfio /sbin/modprobe --ignore-install cfio && /sbin/modprobe mcf25
I then opened /etc/network/interfaces to configure the wifistix, but
that files also has some lines starting with "-e":
iface wlan0 inet dhcp
iface mwlan0 inet dhcp
pre-up /sbin/iwconfig $IFACE essid any txpower 100mW
I checked the build_arm_nofpu/root/etc/... version of these files on
the host, and they have those extra lines there too - so this was not
caused by transfer errors.
Any idea what can cause this? I'm using rev. 1313 of the buildroot. I
haven't checked if other files are containing these errors as well.