On Tuesday 11 April 2006 23:38, xpto09 wrote:
> On 4/10/06, xpto09 <xpto09@...> wrote:
> > On 4/9/06, Jeff Dike <jdike@...> wrote:
> > > On Sun, Apr 09, 2006 at 08:55:09PM -0300, xpto09 wrote:
> > > > 1) Configuring an eth0 device
> > > > specify eth0 on the command line:
> > > >
> > > > eth0=tuntap,,,192.168.0.254
> > > >
> > > > Inside the uml I put the command above.
> > >
> > > Would it be any clearer if it said to put the eth=... on the UML
> > > command line
> > > on the host?
> > >
> > > Jeff
> > The answer is "yes".
> > I found a solution:
> To become easier I renamed the Fedora... to root_fs.
> I had to put the parameter rw because Fedora was only readable.
But it's normal - the boot process is supposed to remount the fs read write.
> Before the rw, the boot was very slow.
Maybe it did the disk check and now it skips it as the fs is already mounted.
However that's ok as long as you're using a journaled fs.
> I installed slirp in the host.
> apt-get install slirp
> To run root_fs:
> ./linux-2.6.16 rw eth0=slirp,,/usr/bin/slirp
That is fine, but is uncommon and maybe slower... However, if it's ok for you
don't worry... indeed it's the setup with less parameters.
Inform me of my mistakes, so I can keep imitating Homer Simpson's "Doh!".
Paolo Giarrusso, aka Blaisorblade (Skype ID "PaoloGiarrusso", ICQ 215621894)
Yahoo! Messenger with Voice: chiama da PC a telefono a tariffe esclusive