Thank you Mark,
Disabling EHCI seems to allow it to work. I played with it for about 10
minutes without hiccup.
Then I put EHCI back in and the same problem arose.
Giridhar, I'm sorry. I only joined the list yesterday, and I thought
there would be a simple solution to this, and the mailing list limits my
sending to 40KB per message.
However, when I switch on tracing, nothing works at all!
I have attached two traces, with and without EHCI. Both fail when
tracing is switched on, yet only the one with EHCI fails when tracing is
off.
It seems that my long description seems to have found a solution faster
than the bugtrace for now. :-)
Cheers,
Tudor.
Giridhar Pemmasani wrote:
> As I often have to repeat: Submit debug trace showing what causes the
> problem. Long descriptions of symptoms won't help.
>
> For the record, latest snapshot worked fine for me without issues with
> couple of USB devices, including WG111 with the driver mentioned.
>
>
mark wrote:
> This sounds very similar to my problem. Except that I just have to unplug
> mine from my USB cradle in order to reset its state. It did work very nicely
> with very old versions of ndiswrapper, but they did crash from time to time,
> and it took my entire machine down, so I stick with these more recent
> versions of ndiswrapper.
>
> Try removing your ehci-hcd module and see if that improves your stability.
> Also, try to remove any usb mice or other usb peripherals and see if that
> increases the devices up-time.
>
|