Am Don, 2003-06-19 um 03.13 schrieb Poul Petersen:
> Hmm. I must be doing something wrong here. I built a homebrew
> receiver and then built lirc-0.6.6, specifying the homebrew and
> /dev/ttyS0 as the device. I've got the serial driver built as a module
> (RedHat 9 but kernel 2.4.21) and I've also tried the setserial trick
> mentioned in the troubleshooting section, but I'm not having any luck
> getting the receiver to work. I load lirc_serial and then run mode2, but
> it never shows any signals. I probed the RTS line and it never goes to
> +12V contrary to the documentation which I believe states the lirc will
> pull RTS high. What am I missing? Can I just disconnect the RTS line and
> pull it up manually? I suppose this might at least be a good test...
Hi Poul,
as i have wrote some days ago, i had have the same problem with an ASUS
TX97 (a Pentium MMX board). You can (as you have wrte) substitute the
RTS line with the 12V from the drive power connector.
Same solution, if the board only gives to low voltage over the RTS pin
as my VIA Epia 5000 does ...
Oliver
|