On Thu, 17 Mar 2005 10:41:30 -0500, Ed L Cashin wrote:
> Paul Ionescu <i_p_a_u_l@...> writes:
>> I use vblade-4 to export a test fs like: ./vblade 8 1 eth0 /dev/ram1
>> If I "cat /dev/etherd/e8.1 > /dev/null" from another system, I get
>> cat /dev/etherd/e9.0 > /dev/null
>> cat: /dev/etherd/e9.0: Input/output error
>> If I use vblade-1 to export the test fs, I don't get that error message.
>> I did not test vblade 2 and 3, but I think they are the same as 4.
> You are quite right. There was a change made in vblade-2 that lacked a
> finishing touch. The last couple sectors on the exported device were
> inaccessible in vblades 2, 3, and 4.
> I just released vblade-5, and you should find the behavior to be what
> you'd expect now.
> Thanks very much for pointing the issue out!
Tested vblade-5, and it works OK.