I am running a gumstix/robostix platform with no tweener board. I am
communicating with the gumstix via the gumstix serial breakout on the
robostix. I am using an Acroname Robotics S19-USB-INTCONN between my
computer and the robostix. I am powering the robostix with a 11.1V
nominal LiPo plugged into the robostix through the V_POWER port. (The
specs say that the robostix can take 6-12V.)
After powering up the robostix, I see the boot messages on my serial
terminal. The gumstix reboots, however, in the middle of the boot
sequence. Every time it reboots, it goes through less and less of the
boot sequence. Attached to this email is a text dump of my boot messages.
If anyone knows what is going on, I would greatly appreciate some help.