On 2010-10-12 14:53-0600 Orion Poplawski wrote:
> These files are getting installed:
> but I don't think they should be as the generated tk0* files are already
> installed as well.
Sorry for getting back to you so late on this one. The issue is that
there are two supported build systems for installed examples. The
traditional Makefile + pkg-config one, and the CMake-based one. The
former demands tk?? be installed while the latter currently demands
tk??.in be installed because the the CMake-based build system for the
installed examples follows the CMake-based build system for the PLplot
core by configuring tk??. Of course, that CMake logic for the
installed examples build could be changed to replace that
configuration by copying tk?? from the source tree to the build tree
for the examples. I would be happy to accept a patch to that effect.
However, the current logic does provide correct results for the two
installed examples build systems at the expense of the tk?? versus
tk??.in redundancy you noticed in the installed examples tree.
Alan W. Irwin
Astronomical research affiliation with Department of Physics and Astronomy,
University of Victoria (astrowww.phys.uvic.ca).
Programming affiliations with the FreeEOS equation-of-state implementation
for stellar interiors (freeeos.sf.net); PLplot scientific plotting software
package (plplot.org); the libLASi project (unifont.org/lasi); the Loads of
Linux Links project (loll.sf.net); and the Linux Brochure Project