I'm using zhcon 0.2.1.
I have installed it on my test system and it works fine.
On my target system the the screen goes black/blank a few seconds after my
I can get the screen back by swiching between consoles (CTRL-ALT-F2 and then
back with CTRL-ALT-F2). After doing so the screen is ok again and stays ok!
zhcon har not been installed/compiled on the target system - but the
binaries has been moved onto the target system from the system where the
target kernel was originally compiled.
Target system: 100 MHz 486 / 32M byte RAM / disk 64 M byte DiskOnChip
(readOnly file system) no swap file. Graphical chip HM86508 / 1M byte video
memory (the cpu board is called Wafer 4823)
Appiication uses ncurses and gpm. gpm has been patched.
Hope for some answers
Svend Erik Nissen
Få alle de nye og sjove ikoner med MSN Messenger http://messenger.msn.dk