In my build (1431) I was able to get SSP support by modifying
arch/arm/mach-pxa/Kconfig (in the Linux kernel source directory), then
rebuilding the kernel. Towards the top of the file, I have:
bool "Gumstix Platform"
depends on ARCH_PXA
I did this about 6 months ago and can't recall if there was anything
else I needed to do, but I think this is it.
Hope that helps...
[mailto:gumstix-users-bounces@...] On Behalf Of Lee
Sent: Thursday, December 27, 2007 7:57 PM
Subject: [Gumstix-users] Enabling SSP in the kernel
I am trying to enable the nssp/ssp port available on the console-lcd
breakout board in order to interface with the knockoff Nokia 6100 LCD
following the instruction on this wiki page
I am unable to find the gumstix configuration in Kconfig. The wiki has a
note to add the new location however it hasn't been added.
Does anyone know where it is. Or have any instructions for communicating
with the screen for the current buildroot? Any advice or help is
NOTE: The information in this message is intended for the personal and conf=
idential use of the designated recipient(s) named above. To the extent the =
recipient(s) is/are bound by a non-disclosure agreement, or other agreement=
that contains an obligation of confidentiality, with AuthenTec, then this =
message and/or any attachments shall be considered confidential information=
and subject to the confidentiality terms of that agreement. If the reader=
of this message is not the intended recipient named above, you are notifie=
d that you have received this document in error, and any review, disseminat=
ion, distribution or copying of this message is strictly prohibited. If you=
have received this document in error, please delete the original message a=
nd notify the sender immediately. =0D
AuthenTec, Inc. http://www.authentec.com=0D