I just received two tobi boards, but so far I'm not able to get the
Ethernet port to show up. My most recent test was based on the palmtop
"ifconfig -a" does not show anything other than the loopback device. The
same thing happens for both tobi boards.
Is there some configuration action I need to take in order to get the
right pieces in the system?
NOTE: The information in this message is intended for the personal and confidential use of the designated recipient(s) named above. To the extent the recipient(s) is/are bound by a non-disclosure agreement, or other agreement that contains an obligation of confidentiality, with AuthenTec, then this message and/or any attachments shall be considered confidential information and subject to the confidentiality terms of that agreement. If the reader of this message is not the intended recipient named above, you are notified that you have received this document in error, and any review, dissemination, distribution or copying of this message is strictly prohibited. If you have received this document in error, please delete the original message and notify the sender immediately.
AuthenTec, Inc. http://www.authentec.com