On Wed, Dec 10, 2008 at 4:49 AM, Daniel Jomphe <amis@...> wrote:
> Is my installation fine? Is there something I should try to make it better?
SBCL itself is probably working fine, but something in your
environment screws up SB-POSIX. Installing the SBCL you have just
built is OK, but if you install it as-is SB-POSIX will *not* be
installed along with it, which is not good as many things (like Slime)
depend on it. Assuming SB-POSIX build, but didn't pass its tests you
can trick install.sh to install it by doing
but it would be better to figure out what went wrong and fix it -- be
the problem in SBCL or with your setup.
If you run
sh make-target-contrib.sh &> log
in the directory after the failed build, and then look for the actual
SB-POSIX failure in the log (either a build or a test failure), what
does it look like? If you can't locate it, you can zip the logfile and
send it to me, and I'll have a look.