I'm trying to create a new lircd.conf file for a Bell ExpressVu DSS
remote. I've done fairly well so far, except that repeats don't work.
irrecord doesn't work because it can't see a gap.
Does anyone know where I can find a description of the keywords and
flags used in lircd.conf? I've tried the source code, but I'm quite
new to the project, so I'd have to spend more time than I have right
now to figure it out. Perhaps there's already a config file available,
but I haven't found it yet.
I have analyzed the signal from the remote closely, so I know exactly
what it's doing, it's just a matter of learning the meaning and usage
of the lircd.conf keywords and flags.
Thanx in advance,