> It looks like I can use ffuart or hwuart from the 60-pin hirose. Is
> there 3.3v power available on this connector? I don't see it.
Nope - No 3.3v power. If you look at the waysmall board, you;ll see a
tiny little voltage regulator (I think its a MIC5255). It's the tiny
little black chip just beside the power jack (on the USB connector
> I need to use the audiostix board at the same time as this new module,
> but I do have a tweener. Is there any better way to get at the uart pins
> than tapping into where the tweener's male/female hirose connectors are
> soldered together?
The vias on the tweener board are probably your best bet. 30 gauge
wire wrap wire will fit nicely in the holes.
I think that the UART on the gumstix can run at 921k but I'm not 100% sure.
Vancouver, BC, Canada