Trying to figure out how to load the Prolific USB-serial driver on Overo Air. Here's what I have done to try and load the pl2303 module:
opkg update (w/o doing this step first, installing the pl2303 module fails)
opkg install kernel-module-pl2303
After I did that, the Prolific module was located at:
However, Prolific devices are still not being mounted at /dev/ttyUSBX. If I try to manually load the module using:
then I get the message:
FATAL: Module pl2303 not found.
Using insmod doesn't work either:
Get the error message:
insmod: error inserting 'pl2303.ko': -1 Invalid module format
I'm not sure how to get the kernel to recognize this new module. I think part of the problem is that in /lib/modules I now have 2 directories: 2.6.30-omap1 and 2.6.32, where the 2.6.32 branch only contains the pl2303 module (and nothing else).
John P. Wilson
Erigo Technologies LLC
64 Main St./P.O. Box 899
Enfield, NH 03748
Notice: This email (including attachments) is covered by the Electronic Communications Privacy Act, 18 U.S.C. §§ 2510-2521, is confidential and may be legally privileged. If you are not the intended recipient, you are hereby notified that any retention dissemination, distribution, or copying of this communication is strictly prohibited. Please reply to the sender that you have received the message in error, and then delete it. Thank you.