------- Comment #35 from scatmanwalks@... 2008-01-18 07:37 -------
We are kind of getting somewhere.
I booted with 184.108.40.206 today, after re-compiling with CONFIG_ACPI_DEBUG=y as
you mentioned. I wasn't really getting any extra input at the end of the
process. I typed "halt" and then it would just sit and wait for a power off,
like when I was adding acpi=off to kernels that wouldn't shut my machine down,
and just reboot instead. However, I then noted your last comment of "using
halt instead of poweroff".
So I thought I would type "poweroff" instead of "halt". When I did this, the
machine powered off properly. However, it would only do this on the kernel
with SUSPEND and HIBERNATE disabled. If I tried it with the generic CentOS 5
kernel, it would just reboot as it was doing previously.
Here is the lspci -vv for the Adaptec card:
00:0b.0 SCSI storage controller: Adaptec AIC-7892B U160/m (rev 02)
Subsystem: Adaptec 19160 Ultra160 SCSI Controller
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr-
Stepping- SERR+ FastB2B-
Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (10000ns min, 6250ns max), Cache Line Size: 32 bytes
Interrupt: pin A routed to IRQ 177
BIST result: 00
Region 0: I/O ports at dc00 [disabled] [size=256]
Region 1: Memory at dffff000 (64-bit, non-prefetchable) [size=4K]
Expansion ROM at dffc0000 [disabled] [size=128K]
Capabilities: [dc] Power Management version 2
Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
will that lspci output help in some way to allow SUSPEND and HIBERNATE to
co-exist with the Adaptec module than to have it disabled and removed like we
have done so far? The module is aic7xxx.
Configure bugmail: http://bugzilla.kernel.org/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug, or are watching someone who is.