Greetings!
I'm currently migrating from a (slightly hacked) STLport 5.0 to the officia=
l=20
STLport 5.1, and I found a small bug in configure.bat: in line 356, the cod=
e=20
to set the target processor subtype has been commented out, but it is=20
required to distinguish between the two or three different ARM architecture=
s.=20
FYI, unfortunately that can't be determined at compile-time because the=20
compiler seems to not export a suitable macro.
Note: this line was commented in revision 2548, as part of an "EVC patch fr=
om=20
Eric Sanford for emulator build".
Uli
line 356:
REM echo TARGET_PROC_SUBTYPE=3D%TARGETCPU% >> ..\Makefiles\config.mak
--=20
Sator Laser GmbH
Gesch=E4ftsf=FChrer: Ronald Boers Steuernummer: 02/892/02900=20
Amtsgericht Hamburg HR B62 932 USt-Id.Nr.: DE183047360
***************************************************************************=
***********
Visit our website at <http://www.satorlaser.de/>
***************************************************************************=
***********
Diese E-Mail einschlie=DFlich s=E4mtlicher Anh=E4nge ist nur f=FCr den Adre=
ssaten bestimmt und kann vertrauliche Informationen enthalten. Bitte benach=
richtigen Sie den Absender umgehend, falls Sie nicht der beabsichtigte Empf=
=E4nger sein sollten. Die E-Mail ist in diesem Fall zu l=F6schen und darf w=
eder gelesen, weitergeleitet, ver=F6ffentlicht oder anderweitig benutzt wer=
den.
E-Mails k=F6nnen durch Dritte gelesen werden und Viren sowie nichtautorisie=
rte =C4nderungen enthalten. Sator Laser GmbH ist f=FCr diese Folgen nicht v=
erantwortlich.
***************************************************************************=
***********
|