This is what I get from my DS10A install:
# 03/26/05 05:37:22 PM Unmatched incoming serial data=RBE01
# 03/26/05 05:37:21 PM Unmatched incoming serial data=RBE00
I can't seem to correlate this to the code listing in the email below.
I have put in:
RF, BE, front_gate_switch, Sensors|Outside, DS10A
In my .mht file and mh isn't showing it in any logs.
Any suggestions? I have a handful of these to install, and I can't figure
out the definition.
> -----Original Message-----
> From: misterhouse-users-admin@...
> [mailto:misterhouse-users-admin@...] On
> Behalf Of Gregg Liming
> Sent: Saturday, February 19, 2005 5:06 PM
> To: misterhouse-users@...
> Subject: Re: [misterhouse-users] DS10A
> Quoting Larry Roudebush (2/19/05 1:42 PM):
> > I am trying to figure out how to put a ds10a in the mht or give it
> > some kind of definition.
> You mean like this? :
> # DS10A security
> RF, d7, basement_door_switch, Sensors,
> RF, b8, front_door_switch, Sensors,
> > I see the log file give me this... 02/19/05
> > 01:24:19 PM W800: security: unmatched device 0xd9 (state = AlertMin)
> My batteries are too good as I've not had to recently replace
> and re-determine their code. If I remember correctly, these
> devices "assert" their code and that code is "announced" as
> part of the error info. So, (now, from a long time back) is
> it possible that your code is d9?
> I do *definitely* remember that the device code changes on
> each battery or reset operation.