------- Additional Comments From gfernandez-victorio@... 2003-11-14 14:55 -------
>Can you attach the full dmesg and /proc/interrupts of a recent kernel booted
>w/ no cmdline flags?
Attached. Also attached config.gz.
I've discovered a few "sleeping function" in test9 that used not to appear.
Maybe should I post to LKML?
>If you attach the output from dmidecode, that would tell us.
>Probably if you use cmdline option "lapic", it will over-ride this and
>you can see if the system still fails with the LAPIC enabled.
Yes. With lapic in cmdline, it freezes at boot. Last lines are
ACPI: Subsystem revision 20031002
ACPI:IRQ 9 was Edge TRiggered, setting to Level Triggered
>dmesg with acpi enabled, show an issue too:
>> ACPI: No IRQ known for interrupt pin A of device 0000:00:10.0
>This device is IDE
>> 00:10.0 IDE interface: ALi Corporation M5229 IDE (rev c4) (prog-if fa)
>which the AML shows is on LNK5. But ide0 seems to find itself
>on irq14 correctly anyway. Unclear why LNK5 fails.
Yes. I saw the message, and I was considering to fill a bug. But as IDE works,
and google on similar problems doesn't conclude anything, I thought it wasn't
important. Now I see it is.
>Please verify that you're running the latest BIOS on the system.
I promise to not buy another Compaq if they fail to provide a BIOS update that
not requires, not even MS-DOS, but WindowsXP: Updating the BIOS have been a bit
changelling. BIOS Version is now KH.F.13
------- You are receiving this mail because: -------
You are on the CC list for the bug, or are watching someone who is.