On Sat, 22 Nov 2003 10:45:40 +0100,
"Gilles Espinasse" <gilles.espinasse@...> wrote in message
> ----- Original Message -----
> From: "Blademan" <blademan@...>
> To: "IPcop-devel" <ipcop-devel@...>
> Sent: Saturday, November 22, 2003 1:53 AM
> Subject: [IPCop-devel] Confirm location of makefile for IPCOP
> > I wanted to confirm that the location for the makefile for IPCOP is
> > located in cvs at:
> > /ipcop/ipcop/make.sh
> > I'm gonna take a crack at making a Gentoo (http://www.gentoo.org)
> > ebuild. I'd like to see if we could build IPCOP for other arch such
> > as ppc and sparc. That way I can put my x86 P3 to better use. So I
> > wanted to confirm the loacation of the correct makefile before I get
> > knee deep into the process.
> > TIA and Cheers for a great product,
> > Blademan
> > Gentoo Dev
> It's may be not an easy task. All .rpm are 386.rpm.
..well, all these can be built from sources and the .spec files,
with 'rpmbuild -ta $sourceball ', another way is go the .deb
route, this would likely enable ipcop to support the same
hardware as all Debian ports.
> Some usb adsl driver should compile for ppc, other not. I am not
> optimistic for sparc.
> Even if I know some of us try to use gentoo to compile IPCop for 386,
> I don't think someone succeed to run the result due to glibc errors.
> You may be interested by this post even if it's in french
> Good luck!
..http://google.com/language_tools?hl=en ate above and produced:
..med vennlig hilsen = with Kind Regards from Arnt... ;-)
...with a number of polar bear hunters in his ancestry...
Scenarios always come in sets of three:
best case, worst case, and just in case.