Thanks. Your are right, that was the reason.
I thought, I canceled this mailinglist-post.
I would suggest, qucs' behavior should be changed, so that you can't exit the editing mode
with ESC. What would you want to do in this -doing-nothing-mode-? Also, this is a behavior
that I know from no other software. Switching back to editing mode with ESC after
deleting/moving/whatever is ok, but not switching in none-mode with ESC.
What do you think?
----- Original Message -----
> From: "Stefan Jahn" <stefan@...>
> To: "Carsten Koegler" <ckoegler@...>
> Cc: qucs-bugs@...
> Sent: Friday, April 8, 2011 10:05:05 AM
> Subject: Re: [Qucs-bugs] No mouse-left-click selection possible in schematic
> Am Fr, 25.03.2011, 14:24 schrieb Carsten Koegler:
> > Hello
> > Quite often the following condition occurs with Qucs 0.0.15 and
> > 0.0.16:
> > During editing suddenly I can't select any objects anymore with a
> > mouse-left-click.
> > - Right-click works.
> > - adding components works.
> > - selecting any objects with left-click in the "Dock Window", Menus
> > or
> > Toolbar works.
> > Opening another project clears the situation. It occurs in irregular
> > intervals.
> > Qucs is running under debian 5.0.6 / 64Bit
> I believe this is not a bug. Is it possible you pressing ESC key by
> accident? ESC key is used to switch from/to editing mode in Qucs
> schematic editing...
> Best regards, Stefan.