On Sat, 2010-01-23 at 15:59 -0500, Thom Paine wrote:
> How do other users configure their mh.private.ini file? Do you start
> with a blank file and then start putting in the config that you want
> to enable? Or do you start with a copy of the mh.ini file and then put
> in all the config changes in there, rather than editing the mh.ini
> file in the main install folder?
> I have an X10 only config, so I was wondering if I should just delete
> all the hardware not related to X10 to make my config file smaller and
> easier to manage?
Most I think, usually start with an example from the wiki or forums and
then add bits and pieces after.
Here is mine.
W800_module = X10_W800
W800_port = /dev/mh_w800_port
weeder_port = /dev/mh_weeder_port
weeder_baudrate = 9600