I did the stupid thing to order an infrared reciever, which I do not
know how it works (which pins to use).
It kind of works under winlirc as RX device, but only replies with once
when I transmit with the remote control. After that I do have to restart
the driver. Under linux I was not able to recognice anything at all.
The pins used on the 9-pin SUB-D are: 2(RX),4(DTR),5(SG),7(RTS),8(CTS)
(The device is a round knob with IR receiver, and SUB-D connector P/N:
160806 - if that helps)
Can you help me either find the right driver, or how to debug the
device, so I can use another driver (modified).