No, the output was ok, it was like:
"Error 1 occurred at disk power-on lifetime: 465 hours (19 days + 9 hours)
When the command that caused the error occurred, the device was active or
It was truncated in mail but is present in the output log file I have sent
previously. This message comes every time so it is reproducible.
Hope this helps...
On Wed, Jun 1, 2011 at 1:09 AM, Christian Franke <
> Anshul Soni wrote:
>> I ran the tool recently and my hard disk passed all the tests it did. only
>> one error output is what I am unable to understand. Attached is the full
>> error output. Also, the error log is below for reference. Could you please
>> Complete error log:
>> SMART Error Log Version: 1
>> ATA Error Count: 1
>> CR = Command Register [HEX]
>> Powered_Up_Time is measured from power on, and printed as
>> DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
>> SS=sec, and sss=millisec. It "wraps" after 49.710 days.
>> Error 1 occurred at disk power-on lifetime: 465 hours (19 days + 9 hours)
> Normally the last line should be:
> " When the command that caused the error occurred, the device was ..."
> Is the output actually truncated after 'W'. If yes, is this reproducible?