Hello Phil,
Thanks so much for adding my maxtor drives to the database. I've
included the output from smartctl -a /dev/hda below and am wondering if
I need to be concerned about the error messages which appear below the
attribute list.
Thanks,
Adam Kosmin
root (akosmin@...) wrote:
" smartctl version 5.27 Copyright (C) 2002-4 Bruce Allen
" Home page is http://smartmontools.sourceforge.net/
"
" === START OF INFORMATION SECTION ===
" Device Model: Maxtor 5T040H4
" Serial Number: T4HEBWPC
" Firmware Version: TAH71DP0
" Device is: In smartctl database [for details use: -P show]
" ATA Version is: 6
" ATA Standard is: ATA/ATAPI-6 T13 1410D revision 0
" Local Time is: Mon Jan 19 00:17:43 2004 EST
" SMART support is: Available - device has SMART capability.
" SMART support is: Enabled
"
" === START OF READ SMART DATA SECTION ===
" SMART overall-health self-assessment test result: PASSED
"
" General SMART Values:
" Offline data collection status: (0x80) Offline data collection activity was
" never started.
" Auto Offline Data Collection: Enabled.
" Self-test execution status: ( 0) The previous self-test routine completed
" without error or no self-test has ever
" been run.
" Total time to complete Offline
" data collection: ( 30) seconds.
" Offline data collection
" capabilities: (0x1b) SMART execute Offline immediate.
" Auto Offline data collection on/off support.
" Suspend Offline collection upon new
" command.
" Offline surface scan supported.
" Self-test supported.
" No Conveyance Self-test supported.
" No Selective Self-test supported.
" SMART capabilities: (0x0003) Saves SMART data before entering
" power-saving mode.
" Supports SMART auto save timer.
" Error logging capability: (0x01) Error logging supported.
" No General Purpose Logging support.
" Short self-test routine
" recommended polling time: ( 2) minutes.
" Extended self-test routine
" recommended polling time: ( 25) minutes.
"
" SMART Attributes Data Structure revision number: 16
" Vendor Specific SMART Attributes with Thresholds:
" ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
" 1 Raw_Read_Error_Rate 0x000a 253 252 000 Old_age Always - 107
" 3 Spin_Up_Time 0x0027 195 193 063 Pre-fail Always - 13517
" 4 Start_Stop_Count 0x0032 253 253 000 Old_age Always - 259
" 5 Reallocated_Sector_Ct 0x0033 253 253 063 Pre-fail Always - 0
" 6 Read_Channel_Margin 0x0001 253 253 100 Pre-fail Offline - 0
" 7 Seek_Error_Rate 0x000a 253 243 000 Old_age Always - 0
" 8 Seek_Time_Performance 0x0027 249 246 187 Pre-fail Always - 38329
" 9 Power_On_Minutes 0x0032 222 222 000 Old_age Always - 991h+54m
" 10 Spin_Retry_Count 0x002b 233 227 223 Pre-fail Always - 11
" 11 Calibration_Retry_Count 0x002b 253 252 223 Pre-fail Always - 0
" 12 Power_Cycle_Count 0x0032 253 253 000 Old_age Always - 196
" 196 Reallocated_Event_Count 0x0008 253 253 000 Old_age Offline - 0
" 197 Current_Pending_Sector 0x0008 253 253 000 Old_age Offline - 0
" 198 Offline_Uncorrectable 0x0008 253 253 000 Old_age Offline - 0
" 199 UDMA_CRC_Error_Count 0x0008 199 199 000 Old_age Offline - 0
" 200 Multi_Zone_Error_Rate 0x000a 253 252 000 Old_age Always - 0
" 201 Soft_Read_Error_Rate 0x000a 253 252 000 Old_age Always - 27
" 202 TA_Increase_Count 0x000a 253 252 000 Old_age Always - 0
" 203 Run_Out_Cancel 0x000b 253 252 180 Pre-fail Always - 0
" 204 Shock_Count_Write_Opern 0x000a 253 252 000 Old_age Always - 0
" 205 Shock_Rate_Write_Opern 0x000a 253 252 000 Old_age Always - 0
" 207 Spin_High_Current 0x002a 241 238 000 Old_age Always - 7
" 208 Spin_Buzz 0x002a 246 244 000 Old_age Always - 4
" 209 Offline_Seek_Performnce 0x0024 253 253 000 Old_age Offline - 0
" 96 Unknown_Attribute 0x0004 253 253 000 Old_age Offline - 0
" 97 Unknown_Attribute 0x0004 253 253 000 Old_age Offline - 0
" 98 Unknown_Attribute 0x0004 253 253 000 Old_age Offline - 0
" 99 Unknown_Attribute 0x0004 253 253 000 Old_age Offline - 0
" 100 Unknown_Attribute 0x0004 253 253 000 Old_age Offline - 0
" 101 Unknown_Attribute 0x0004 253 253 000 Old_age Offline - 0
"
" SMART Error Log Version: 1
" Warning: ATA error count 344 inconsistent with error log pointer 5
"
" ATA Error Count: 344 (device log contains only the most recent five errors)
" CR = Command Register [HEX]
" FR = Features Register [HEX]
" SC = Sector Count Register [HEX]
" SN = Sector Number Register [HEX]
" CL = Cylinder Low Register [HEX]
" CH = Cylinder High Register [HEX]
" DH = Device/Head Register [HEX]
" DC = Device Command Register [HEX]
" ER = Error register [HEX]
" ST = Status register [HEX]
" Timestamp = decimal seconds since the previous disk power-on.
" Note: timestamp "wraps" after 2^32 msec = 49.710 days.
"
" Error 344 occurred at disk power-on lifetime: 9485 hours
" When the command that caused the error occurred, the device was in an unknown state.
"
" After command completion occurred, registers were:
" ER ST SC SN CL CH DH
" -- -- -- -- -- -- --
" 04 51 00 00 00 00 a0 Error: ABRT
"
" Commands leading to the command that caused the error were:
" CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
" -- -- -- -- -- -- -- -- --------- --------------------
" a1 00 00 00 00 00 a0 00 181875.184 IDENTIFY PACKET DEVICE
" ca 00 08 85 ee 08 e0 00 181875.040 WRITE DMA
" ca 00 06 85 dd 0f e0 00 181875.040 WRITE DMA
" ca 00 08 85 ee 08 e0 00 181875.040 WRITE DMA
" ca 00 06 85 dd 0f e0 00 181875.040 WRITE DMA
"
" Error 343 occurred at disk power-on lifetime: 9485 hours
" When the command that caused the error occurred, the device was in an unknown state.
"
" After command completion occurred, registers were:
" ER ST SC SN CL CH DH
" -- -- -- -- -- -- --
" 04 51 00 00 00 00 a0 Error: ABRT
"
" Commands leading to the command that caused the error were:
" CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
" -- -- -- -- -- -- -- -- --------- --------------------
" a1 00 00 00 00 00 a0 00 181708.224 IDENTIFY PACKET DEVICE
" c4 00 01 88 ee 08 e0 08 181707.632 READ MULTIPLE
" c4 00 01 87 ee 08 e0 08 181707.632 READ MULTIPLE
" c4 00 01 86 ee 08 e0 08 181707.632 READ MULTIPLE
" c4 00 01 85 ee 08 e0 08 181707.632 READ MULTIPLE
"
" Error 342 occurred at disk power-on lifetime: 9485 hours
" When the command that caused the error occurred, the device was in an unknown state.
"
" After command completion occurred, registers were:
" ER ST SC SN CL CH DH
" -- -- -- -- -- -- --
" 04 51 00 00 00 00 a0 Error: ABRT
"
" Commands leading to the command that caused the error were:
" CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
" -- -- -- -- -- -- -- -- --------- --------------------
" a1 00 00 00 00 00 a0 00 181173.072 IDENTIFY PACKET DEVICE
" c4 00 01 01 00 00 e0 08 181170.576 READ MULTIPLE
" c4 00 01 00 00 00 e0 08 181170.576 READ MULTIPLE
" c4 00 1f 43 93 82 e0 08 181170.576 READ MULTIPLE
" c4 00 1a 29 93 82 e0 08 181170.576 READ MULTIPLE
"
" Error 341 occurred at disk power-on lifetime: 9485 hours
" When the command that caused the error occurred, the device was in an unknown state.
"
" After command completion occurred, registers were:
" ER ST SC SN CL CH DH
" -- -- -- -- -- -- --
" 04 51 00 bf 54 0b a0
"
" Commands leading to the command that caused the error were:
" CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
" -- -- -- -- -- -- -- -- --------- --------------------
" 08 00 00 bf 54 0b a0 08 180468.464 DEVICE RESET
" c4 00 20 af 54 0b e0 08 180468.448 READ MULTIPLE
" c4 00 20 8f 54 0b e0 08 180468.448 READ MULTIPLE
" c4 00 20 6f 54 0b e0 08 180468.448 READ MULTIPLE
" c4 00 20 4f 54 0b e0 08 180468.448 READ MULTIPLE
"
" Error 340 occurred at disk power-on lifetime: 9449 hours
" When the command that caused the error occurred, the device was in an unknown state.
"
" After command completion occurred, registers were:
" ER ST SC SN CL CH DH
" -- -- -- -- -- -- --
" 04 51 00 bf 54 0b a0
"
" Commands leading to the command that caused the error were:
" CR FR SC SN CL CH DH DC Timestamp Command/Feature_Name
" -- -- -- -- -- -- -- -- --------- --------------------
" 08 00 00 bf 54 0b a0 08 353.456 DEVICE RESET
" c4 00 20 af 54 0b e0 08 353.440 READ MULTIPLE
" c4 00 20 8f 54 0b e0 08 353.440 READ MULTIPLE
" c4 00 20 6f 54 0b e0 08 353.440 READ MULTIPLE
" c4 00 20 4f 54 0b e0 08 353.440 READ MULTIPLE
"
" SMART Self-test log structure revision number 1
" Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
" # 1 Short offline Completed without error 00% 10145 -
" # 2 Short offline Completed without error 00% 10145 -
" # 3 Short offline Completed without error 00% 10145 -
" # 4 Short offline Completed without error 00% 10145 -
"
"
--
"Yes, Your Honor. Now, where we are so far, in at least my
line of reasoning, is I want to walk the Court through enough of our
complaint to help the Court understand that IBM clearly did contribute a
lot of the Unix-related information into Linux. We just don't know what
it is."
-- Kevin McBride SCO vs. IBM 12/05/03
|