I'm trying to initialize a SliderJoint to an initial position... For =
HingeJoint I can set an anchor point with SetAnchor(double x,double y, =
double z ). I looked for something similar for the SliderJoint in the =
documentation, but I couldn't find it.
My problem right now: I would that my SliderJoint is at a precise =
z-position at the beginning of the simulation. But when I start the =
simulation, the joint goes to the value I set with "SetParam( =
dParamLoStop, -0.13 );". My second joint limit (dParamHiStop) is 0.0. =
The strang thing is that the simulation doesn't just start with the =
joint at -0.13, but it starts at -0.33333333 and slowly moves until it =
reaches -0.13. I have a function LiftUp() which I could use to place the =
joint higher, but if I call it before the joint is in position -0.13, it =
doesn't have any effect...
Does anyone know how I could solve this problem?
Thanks a lot