Hello all,
I've 2 of the following cards on my workstation, IBM pSeries, 52A box and
running Fedora Linux on it as my main workstation.
The details of the card as below.
0000:d9:00.0 VGA compatible controller: Matrox Graphics, Inc. MGA G400/G450
(rev 85) (prog-if 00 [VGA controller])
Subsystem: IBM Device 0233
Control: I/O- Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Interrupt: pin A routed to IRQ 327
Region 0: Memory at 400a0000000 (32-bit, prefetchable) [size=32M]
Region 1: Memory at 400a2800000 (32-bit, non-prefetchable) [size=8M]
Region 2: Memory at 400a2000000 (32-bit, non-prefetchable) [size=8M]
[virtual] Expansion ROM at 400a3000000 [disabled] [size=128K]
Capabilities: [dc] Power Management version 2
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
Capabilities: [f0] AGP version 2.0
Status: RQ=32 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64-
HTrans- 64bit- FW- AGP3- Rate=x1,x2
Command: RQ=1 ArqSz=0 Cal=0 SBA- AGP- GART64- 64bit- FW-
Rate=<none>
Kernel driver in use: matroxfb <marvel-linux@...>
I've 2 cards in my partition and want to run a dual monitor setup using dual
cards. (2). I'm currently using matroxfb driver
and pass the kernel parameters during the start,but I've not been able to
get 2 displays running. Has anybody tried this setup?
If yes, can u pls share the steps involved?
Any other driver that can be used?
Cheers
-Ajey
<marvel-linux@...>
|