---Chris Frolik <frolikcc@...> wrote:
> In my 2D top down game, I currently have 3 basic types of tiles.
> tiles, wall tiles, and bouncy wall tiles. Wall tiles are 80% elastic
> (players bounce off with 80 percent of their original velocity, in a
> direction), and bouncy wall tiles are 200% elastic (players bounce
> twice their original velocity). The player's sprite is a tank,
> about a 20 x 20 square. The tiles are 32 x 32 pixels. The tank can
> rotated using the left and right keys, and thrust is applied using the
> up/down keys (The tank is considered to be a "hovercraft", so if you
> thrust in one direction, the tank will continue to move in that
> until it hits a wall). Everything is working well except for
> between the tank and the tiles. To test for this, I decided to test 8
> points on the tank (the 4 corners and the midpoint of each side).
> tile at one these points is a wall, then the tank's x or y velocity is
> reversed (negated). I'm having problems with this, however.
> tank gets stuck in a wall, and the collisions aren't very accurate
> sometimes bounces back prematurely or too late).
> If anyone has a suggestion as to how I should do this (or even
> example code) I would appreciate the help.
> --Chris Frolik
If the maps are just a grid of 32x32 tiles, you should be able to
determine whether or not a point is colliding with a tile easily
enough; just divide the pixel coords for the tank by 32 (shift right
4). Check the tile, if it's a wall tile use the tank coords mod 4 to
get the offset into the tile & check the tank against the tile there.
The tank shouldn't get stuck, but if you have problems, try this:
Each time around, check for a collision after you add the movement
vector to the position & take whatever action is appropriate. Each
time around, check for a collision also BEFORE you add the movement
vector. If there is a collision then, you can skip the collision
detection afterwards, assuming that whatever was supposed to be done
to the tank has already been done. So unless you're managing to move
the tank more than one tile at a time without checking for collisions,
every thing should come out right. This sounds good anyway, I'm
really not too sure about it right now ;).
-- Joshua Heyer
DO YOU YAHOO!?
Get your free @yahoo.com address at http://mail.yahoo.com