I cannot get the (#99498c01 PF Servo Motor) click to see motor
, using an adapter cable as seen here
, to work with my NXT2 brick.
I can get it to work correctly with the IR adapter and with the rechargeable power pack and it will go up in its 7 incremental stages as it's meant to, but when I program a block to operate the motor by 100% or in fact any setting at all the motor will not function, it wont even work using the remote function in the NXT program. All other PF motors work fine with the brick.
The adaptor cables are cut and reconnected using only the black and white cables from the NXT2 cable connected to the 2 middle cables of the PF cable.
Does anyone know if there should be a connection to the 2 outer wires using the Yellow and Blue of the NXT2 cable so it would work correctly, or if that's not the case is it even possible to use the NXT 2 brick with that motor?
Another couple of bits of info if it helps.
1. I am using the 'Move' block in the NXT program. (I have tried all possible settings in this block)
2. I can get all other motors to work with the brick with no problems.
3. I am using a rechargable pack for the NXT 2 brick.
PS: In case you wondering, the reason I'm asking is because the PF servo motor is a lot smaller than the NXT2 servo motor meaning its easier to build around and takes up less room when using it in small vehicles.