janblok wrote:Hello all,
When I change the speed of my NXT brick, it stops for a short while and then it goes on.
Is there a way to overcome this because I do not like it.
I am using the graphical "blocks".
Thanks , Jan.
janblok wrote:janblok wrote:Hello all,
So the question is: is there a way to overcome that stopping between changing speed and/or making a turn while the exact number of wheelturns is not
If a move block is set to a fixed distance or time then the program will wait at that block until it is done before it even looks at the next block. When a fixed time or distance move block ends it stops the motors.
However if you set a move block to unlimited your program will start the motors and immediately continue on to the next block.
Users browsing this forum: No registered users and 1 guest