|Draft -> Wire|
|Draft Line, Draft BSpline|
The Wire tool creates polyline (sequence of lines made of several segments) in the current work plane. It takes the linewidth and color previously set on the Tasks tab. The Wire tool behaves like the Draft Line tool, except that it doesn't stop after two points.
How to use
- Press the button, or press then keys
- Click a first point on the 3D view, or type a coordinate
- Click additional point on the 3D view, or type a coordinate
- Press or , or double-click the last point, or click on the first point to finish or close the wire. If the wire is closed, it will also be a face, even if it appears as wireframe.
- Press or the button to finish the wire, leaving it open
- Press or the button or click on the first point to finish the wire, but making it closed by adding a last segment between the last point and the first one.
- Press , or after a point to constrain the next point on the given axis.
- To enter coordinates manually, simply enter the numbers, then press between each X, Y and Z component.
- Press or click the checkbox to check/uncheck the button. If relative mode is on, the coordinates of the next point are relative to the last one. If not, they are absolute, taken from the (0,0,0) origin point.
- Press or click the checkbox to check/uncheck the button. If continue mode is on, the Wire tool will restart after you finish or close it, allowing you to draw another one without pressing the Wire button again.
- Press snapping your point to the nearest snap location, independently of the distance. while drawing to force
- Press constrain your next point horizontally or vertically in relation to the last one. while drawing to
- Press or press the button to remove the existing segments and start the wire from the last point.
- Press + or press the button to undo the last point.
- Press or the button to have the wire to appear as a face after it has been closed. This simply sets the View->Property of the Wire to "Flat lines" or "Wireframe", so it can easily be changed later.
- Press or the button to abort the current Line command.
- : Specifies if the wire is closed or not
- : Specifies a curvature radius to give to the nodes of the wire
- : Shows an arrow symbol at the last point of the wire, so it can be used as an annotation leader line
The Wire tool can by used in macros and from the python console by using the following function:
makeWire (list or Part.Wire, [closed], [placement], [facemode]) : Creates a Wire object from the given list of vectors or from the given wire. If closed is True or if first and last points are identical, the wire is closed. If facemode is True (and the wire is closed), the wire will appear filled. The current Draft linewidth and color will be used. Returns the newly created object.
import FreeCAD,Draft p1 = FreeCAD.Vector(0,0,0) p2 = FreeCAD.Vector(1,1,0) p3 = FreeCAD.Vector(2,0,0) Draft.makeWire([p1,p2,p3],closed=True)