DAVID is a very low cost sensor system introduced by Dr. Simon Winkelbach and Sven Molkenstruck. It utilizes a standard USB webcam and any sort of hand held laser line projector. This article is about my first impression of the sensor system and the discussion about how to integrate the data into FreeCAD.
I use the follwing hardware for the scan:
- A 10€ Laser line from the hardware store
- A 24€ Trust WebCam 640x480, 17 fps
I will use follwing test parts:
Here is my sensor setup for the first two test parts. It is a corner with a 90° angle and two sheets with the calibration pattern.
So far I use:
- The DAVID sensor wizard
- FreeCAD for post processing
Here are the scans I made with the sensor.
This is my first tryout with the above mentioned sensor hardware:
- First Scan with .OBJ and cleaned .STL files.
Here some ToDos to enable FreeCAD to easily incorporate DAVID scanner data:
- A DAVID Workbench
- Own hole closing filter
The following DAVID related features are allready implemented:
- OBJ file format import (Rev:358)
Scans from others
Here a list of published scans from other persons (with no warranty ;-).
MICROSOFT Webcam LifeCam NX-6000 USB 2.0 - 2MB pixel captor works very well in 800×600 at 30 fps grey scale(no saturation), the scan is precise to 0.1 mm (180mm model)with very few noise for 82 Euros wonderful.
Only free software has been used
- MeshLab (noise remove)
- Scanalyse (assembly)